Matters needing attention before and after polishing machine operation

Polishing safety procedures are crucial and should never be overlooked. We believe many people have experience with safe polishing machine operation, so let's take a look. Only by paying attention to this aspect can we operate the machine better and more safely.

1. Check the power supply: Keep the switch intact. Safe startup procedure for the polishing machine: Connect the external power supply → Turn on the main power switch → Turn on the power start switch. Safe shutdown procedure for the polishing machine: Stop the polishing disc → Turn off the power switch → Disconnect the external power supply.

2. Do not randomly connect or pull electrical wires. Switches and sockets must be mounted on the wall. When cleaning or tidying up the equipment, prevent water from splashing onto the power supply.

3. Unauthorized entry into the work area is prohibited.
4. In the event of an emergency while the polishing machine is operating, immediately turn off the main power switch.
5. When removing a workpiece to observe the results, first stop the polishing disc and raise the pressure control arm. Wait until the pressure control arm is fully raised before removing the workpiece to avoid accidents. 6. Do not extend any part of your body into the polishing area while the polishing machine is operating automatically to avoid injury.

7. The worksite floor must be kept clean and tidy, and no items should be left lying around. Before leaving get off work, remember to turn off the main water, electricity, and gas switches.

8. Firefighting equipment must be properly positioned. Workers must master their operation and regularly inspect them for signs of damage and expiration.