Round tube polishing machine operation and installation method

       Tube polishing machine operation method:

　　1、First put the workpiece into the track.

　　2、the center of the workpiece to the center of the wheel.

　　3、Lock the track, so that the track is tilted at a certain angle (the greater the tilt angle, the greater the forward speed of the workpiece).

　　4、 start the guide wheel motor, if the forward speed is appropriate, move the grinding head to the workpiece.

　　5、If there is a threaded shape, it indicates that the forward speed is faster, and the tilt angle of the track can be made smaller.

　　6、To often check whether the reducer lack of oil.

       7、 to often check whether there is a murmur in the grinding head, or a light movement.

       Round tube polishing machine polishing workpiece will not affect the size of the workpiece, especially suitable for the centerless grinder processing after the workpiece high brightness polishing. Round pipe polishing machine has high working efficiency, good surface roughness of the workpiece, stable performance, the machine guide wheel speed frequency control (optional), so regardless of the diameter of the workpiece, can also be processed to the desired purpose. It is the best choice for polishing round tube, round bar, slender shaft and quartz bar.

Second, installation and commissioning

　1、 machine installation: polishing machine, must be placed in the level of painted concrete floor, according to the machine base around the screw holes bolted to the ground to correct the level.

　2、the machine with a distribution box, using 380V three-phase four-wire, distribution box below the 4-seat terminal with change.

　3、debugging speed: turn on the power to rotate the motor speed, hold the button switch, the host that is energized to run, turn the polishing wheel, at this time to see whether the polishing wheel rotating direction is the same as the polishing wheel cover above the arrow, if the direction of the opposite, it is necessary to cut off the power supply, such as the introduction of electricity into the three-phase line of any two-phase adjustments to be connected to the above procedures to re-operate or to turn the actual polishing wheel to turn in the direction of the arrow is the same.