How to use and maintain a pneumatic polisher

When operating the pneumatic polisher, first install the polishing pad and ensure that the screws are tightened and locked; then you can start the polishing procedure. First lift the handle to release the rod, then put down the handle so that the polisher head can float up and down freely; turn the handle toward the safety lock button, then turn the handle forward to open the round tube polisher. After opening successfully, release your thumb from the safety lock button; move the round tube polisher in a "W" shape, or push the automatic polisher forward to start polishing the wax layer of the floor.

After the automatic polisher is started, it is necessary to keep the automatic polisher moving normally to avoid damaging the wax layer and the floor surface; to prevent the motor from overloading, the machine is equipped with a circuit overload protection device. If the circuit breaker is disconnected, wait for 10 seconds before resetting it; when the floor waxing process is completed, the handle should be rotated backwards to disengage the safety lock button to stop the round tube polisher from rolling; after the operation is completed, the automatic polisher should be tilted backwards with the rear wheels on the ground to avoid the appearance of damage to the polishing pad, or the polishing pad can be removed and stored.

How to maintain the pneumatic polisher.

Regular maintenance and repair of the pneumatic polisher can keep the pneumatic polisher in good production and operation condition to ensure normal production.

First of all, we must ensure that the pneumatic polisher is placed stably and firmly, whether there is any looseness or tilt, clean the machine platform of the round tube polisher, and regularly use lubricating oil to maintain the automatic polisher; regularly check the power cord to see if there is any power leakage, and replace the power cord in time if there is; timely maintain the transmission motor, and check and repair it in time if the motor does not rotate or stops; regularly tighten the mechanical screws of the automatic polisher.

Proper maintenance of the equipment can extend the service life of the equipment and further improve the work efficiency in mechanical processing production.